KORG PA4X 76 - Manual (Page 517)

Effect parameters |513
g L LFO Phase [deg] –180…+180 Sets the phase obtained when the left LFO
is reset
L Depth 0…200 Sets the depth of the left LFO modulation
h R LFO Phase [deg] –180…+180 Sets the phase obtained when the right
LFO is reset
R Depth 0…200 Sets the depth of the right LFO modulation
i L Delay Time [msec] 0.0…1000.0 Sets the delay time for the left channel
L Feedback –100…+100 Sets the feedback amount of left delay
j R Delay Time [msec] 0.0…1000.0 Sets the delay time for the right channel
R Feedback –100…+100 Sets the feedback amount of right delay
k Wet/Dry -Wet, -1:99…
Dry…99:1,
Wet Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
b: D-mod Modulation
When the modulation source is used for control, this parameter reverses the
left and right modulation direction.
d: LFO Sync
d: Src
g: L LFO Phase [deg]
h: R LFO Phase [deg]
If “LFO Sync” is On, the LFO will be reset by the modulation source that is
received.
The “Src” parameter sets the modulation source that resets the LFO. For ex-
ample, you can assign Gate as a modulation source so that the sweep always
starts from the specified point.
“L LFO Phase” and “R LFO Phase” set the phase obtained when the left and
right LFOs are reset. In this way, you can create changes in pitch sweep for
the left and right channels individually.
The effect is off when a value of the modulation source specified in the
“Src” parameter is 63 or smaller, and the effect is on when the value is 64
or higher. The LFO is triggered and reset to the “L LFO Phase” and “R LFO
Phase” settings when the value changes from 63 or smaller to 64 or higher.