KORG PA4X 76 - Manual (Page 536)

532| Effects for the Sounds
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+ Delay
Feedback
Low Damp Tone
Input Level
D-mod
a Time 0…2700 This parameter sets the delay time of Tap 1.
Also, Taps 2 and 3 are specified as a percentage
(%) of this delay time. Taps 2 and 3 always stay
in proportion to Tap 1, even when the delay time
is modulated.
Src Off…Tempo Selects the modulation source of Time
Amt –100…+100 Sets the depth by which Time will be modulated
b Feedback 0…100 Sets the amount of feedback
Src Off…Tempo Selects the modulation source of feedback
amount
Amt –100…+100 Sets the depth by which feedback amount will be
modulated
c Tone 0…99 Sets the tone of the input.
This models the reduced high frequencies of an
analog tape delay, before the saturation stage.
Lower settings create a darker tone.
This cuts the high frequencies in both the main
output and the feedback. Higher settings create
a darker tone.
d Low Damp [%] 0…100 Sets the damping amount in the low range
e Input Level Dmod Off…Tempo Selects the modulation source for the Input
Level. See DMS (Dynamic Modulation Source)
Src Off…Tempo Selects the modulation source of Input Level
Dmod
f Wet/Dry Dry, 1:99…99:1,
Wet Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source