KORG PA4X 76 - Manual (Page 535)

Effect parameters |531
n Wet/Dry Dry,
1:99…99:1, Wet Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
a: Tap1 Dmod Src
b: Tap1 Delay Note
b: Times
c: Tap1 Dmod Note
c: Times
If “Tap1 Dmod Src” is Off or the selected modulation is at 0, the delay time
will be the length specified by “Tap1 Delay Note” and “Times.”
If “Tap1 Dmod Src” is other than Off, the delay time will change so that it
will be as specified by “Tap1 Dmod Note” and “Times” when the maximum
modulation is reached.
b: Time Over?
You can set the delay time up to 5,400msec. If the delay time exceeds
this limit, the error message “OVER!” appears in the display. Set the de-
lay time parameters so that this message will not appear. “Time Over?”
is only a display parameter.
Classic Tape Echo
This models a famous analog tape echo unit. On the original device,
“echo” was created by a playback head, and the “delay time” was speci-
fied by adjusting the speed of the motor. The warmth and subtlety of
the echoes it generated made this “lo-fi” unit a favorite with many pro
musicians.