KORG PA4X 76 - Manual (Page 414)

410| Customizing and editing the Sounds
If the Intensity is a positive (+) value, a setting of + will increase the EG level,
and a setting of – will decrease it. With a setting of 0 there will be no change.
Pitch EG change (level) (AMS=JS-Y/Velocity, Intensity= positive (+) value
Note-on
Note-off
Note-on
Note-off
Note-on
Note-off
A note played softly with
Start Level Swing set at 0,
Attack Level Swing set to +,
the Joystick pulled on A note played strongly with
Start Level Swing set to 0,
Attack Level Swing set to +,
the Joystick pulled on A note played strongly with
Start Level Swing set to 0,
Attack Level Swing set to –,
the Joystick pulled on
Modulating the Pitch EG times
Use the Time Modulation > AMS parameter to select a modulation source for
the Pitch EG > Time parameters.
▪ Use the Time Modulation > Intensity parameters (-99…+99) to specify the
depth and direction of the effect that AMS will have on the Time parameters.
With a setting of 0, the pitch EG times will be just as specified by the Time
settings.
The alternate modulation value at the moment that the EG reaches each
point will determine the actual value of the EG time that comes next.
For example, the decay time will be determined by the alternate modulation
value at the moment that the attack level is reached.
When this parameter is set to values of 16, 33, 49, 66, 82, or 99, the specified
EG times will speed up as much as 2, 4, 8, 16, 32, or 64 times respectively (or
slowed down to 1/2, 1/4, 1/8, 1/16, 1/32, or 1/64 of the original time).
For example, with the Velocity AMS, increasing the absolute value of Intensity
will allow strongly-played notes to increase the changes in pitch EG Time val-
ues. The direction of the change is specified by At (Attack Time Swing) and
Dc (Decay Time Swing). As you play more softly, the pitch EG times will more
closely approach the actual settings of the pitch EG.
▪ Use the At (Attack Time Swing) and the Dc (Decay Time Swing) parameters
to specify the direction in which AMS will affect the Time > Attack and Decay
parameter. With positive (+) values of Intensity, a setting of + will cause the