KORG PA4X 76 - Manual (Page 583)

Effect parameters |579
a LFO Waveform Triangle, Sine Selects the LFO Waveform
LFO Shape –100…+100 Changes the curvature of the LFO Waveform
b LFO Phase [de-
gree]
–180…+180 Sets the LFO phase difference between the
left and right
c LFO Frequency
[Hz] 0.02…20.00 Sets the speed of the LFO
Src Off…Tempo Selects a modulation source for LFO speed
Amt –20.00…
+20.00 Sets the modulation amount of LFO speed
d MIDI Sync Off, On When this is on, the LFO speed is set by BPM,
Base Note, and Times, instead of Frequency
BPM MIDI,
40.00…
300.00 MIDI syncs to the system tempo; 40–300 sets
the tempo manually for this individual effect
Base Note
…
Selects the type of notes that specify the LFO
speed
Times x1…x32 Sets the number of notes that specify the LFO
speed
e Depth 0…100 Sets the depth of LFO modulation
Src Off…Tempo Selects the modulation source of the depth of
modulation
Amt –100…+100 Sets the modulation amount of the depth of
modulation
f Wet/Dry Dry, 1:99…99:1,
Wet Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
a: LFO Shape
You can change the panning curve by modifying the LFO’s Shape .
b: LFO Phase [degree]
This determines the phase difference between the left and right LFOs. When
you gradually change the value away from 0, the sounds from the left and
right channels will seem to chase each other around. If you set the parame-
ter to +180 or –180, the sounds from each channel will cross over each other.