KORG PA4X 76 - Manual (Page 387)

Editing the Sounds |383
Choosing and setting the multisamples
▪ Use the High and Low pop-up menus to choose the multisample’s bank (ROM
or RAM).
▪ Use the numeric field next to the multisample name to choose the multi-
sample inside the selected bank.
Bank Meaning
ROM Factory multisamples, supplied by KORG as standard.
RAM User multisamples, loaded when loading some User Sounds.
The High multisample will be triggered by velocities equal or higher than the
Velocity SW L–>H value. If you do not want to use velocity switching, set the
switch to a value of 001, and only assign the High multisample.
▪ Use the Offset parameters to specify the point where the multisample(s) will
start to play. With some multisamples this parameter is not available.
Offset Meaning
Off The sound will start from the beginning of the multisample wave-
form.
1st…6th The sound will begin from the offset location predetermined for each
sample.
No Attack The initial portion of the multisample is ignored.
AMS Activates the Alternate Modulation Source (see below).
PseudoRandom (Only works when more than a single Offset point is available in the
multisample). Randomly selects one of the available Offset points.
▪ Select the Reverse checkbox to reverse the samples in the multisample
(reading starts from the end). This can only be activated on some multi-
samples.
▪ Use the Level parameters to specify the volume level of each multisample.
Depending on the multisample, high settings of this parameter may cause
the sound to distort when a chord is played. If this occurs, lower the level.