KORG PA4X 76 User Manual
Page 388
384| Customizing and editing the Sounds
Setting octave and fine tuning
▪
Use the
Oct(ave)
parameter to adjust the pitch of the selected oscillator in
octave units (-2…+1). The normal octave is 0 (Zero).
▪
Use the
Transpose
parameter to adjust the pitch of the selected oscillator
over a range of
±1 octave (-12…+12 semitones).
▪
Use the
Tune
parameter to adjust the pitch of the sample over a range of
±1
octave (-1200…+1200 cents of a semitone) .
Setting the velocity switch between the Low and High layers
▪
Use the
Vel SW L–>H
parameter to set the velocity value dividing the High
and Low multisamples for the selected oscillator. Notes struck at this value
or harder will be played by the High multisample.
Choosing an AMS (Alternate Modulation Source)
When the
AMS
option is assigned to the
Offset
parameter, the
Offset
Intensity by AMS
and
AMS
parameters become available. A list of AMS
sources can be found in the Appendix.
When the
Offset Intensity by AMS
parameter has a positive value, the se-
lected Offset point will depend by the AMS value. For example, with the
Velocity AMS, playing softly will select the Off or 1st Offset, while playing
loudly will select the 6th or No Attack Offset.
When the
Offset Intensity by AMS
parameter has a negative value, the se-
lection will happen in reverse (higher-numbered Offsets will be selected be-
fore the lowest-numbered ones).