KORG PA4X 76 - Manual (Page 697)

Effect parameters |693
h [F]Cho/Flng Wet/
Dry -Wet, -1:99…
Dry…99:1, Wet Sets the effect balance of the chorus/flanger
Src Off…Tempo Selects the Wet/Dry modulation source for
the chorus/flanger
Amt –100…+100 Sets the Wet/Dry modulation amount for the
chorus/flanger
i [F]Output Mode Normal,
Wet Invert
Selects the output mode for the chorus/
flanger
j Wet/Dry Dry, 1:99…99:1,
Wet Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
i: Output Mode
When Wet Invert is selected, the right channel phase of the chorus/flanger
effect sound is inverted. This creates pseudo-stereo effects and adds spread.
However, if a mono-input type effect is connected after this effect, the left
and right sounds may cancel each other, eliminating the chorus/flanger ef-
fects.
P4EQ - Phaser (Parametric 4-Band EQ - Phaser)
This effect combines a mono four-band parametric equalizer and a phaser.
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Stereo Out / FX Amt = 0: Stereo In - Stereo Out
Trim
+
Parametric 4Band EQ Phaser
Phaser
Resonance
LFO: Tri / Sine
Phaser FX Amt
Normal
Wet Invert
Output Mode
–
+