KORG PA4X 76 - Manual (Page 434)

430| Customizing and editing the Sounds
▪ Use the Time parameters (0…99) to specify the time over which the volume
level is reached.
EG time Meaning
Attack Time over which the volume will change after note-on until it reaches
the attack level. If the start level is 0, this will be the rise time of the
sound.
Decay Time over which the volume will change from when it reaches the
attack level until it reaches the break point level.
Slope Time over which the volume will change from when it reaches the
break point level until it reaches the sustain level.
Release Time over which the volume will change after note-off until it reach-
es 0.
Modulating the Amp EG
Modulating the Amp EG levels
▪ Use the Level Modulation > AMS parameter to select a modulation source
for the Level parameters of the Amp EG.
▪ Use the Level Modulation > Intensity parameters (-99…+99) to specify the
depth and direction of the AMS .
For example, if the AMS is Velocity, setting St (Start Level Swing), At (Attack
Level Swing) and Br (Break Point Level Swing) parameters to + and setting
Intensity to a positive (+) value, will cause the amp EG volume levels to in-
crease as you play more strongly. Setting Intensity to a negative (–) values
will cause the amp EG volume levels to decrease as you play more strongly.
With a setting of 0, the levels will be as specified on
Amp > Amp EG .
▪ Use the St (Start Level Swing) , At (Attack Level Swing) and Br (Break Level
Swing) parameters to specify the direction in which AMS will affect the Level
> Start, Attack and Break Point levels.