KORG PA4X 76 - Manual (Page 688)

684| Effects for the Sounds
St. Analog Record (Stereo Analog Record)
This effect simulates the noise caused by scratches and dust on analog re-
cords. It also reproduces some of the modulation caused by a warped turn-
table.
Left
Right
FX Amt
FX Amt
Stereo In - Stereo Out
Analog Record
Simulation
Pre EQ
Pre EQ
EQ Trim
EQ Trim
a Speed [RPM] 33 1/3, 45, 78 Sets the r.p.m. of a record
b Flutter 0…100 Sets the modulation depth
c Noise Density 0…100 Sets the noise density
Noise Tone 0…100 Sets the noise tone
d Noise Level 0…100 Sets the noise level
Src Off…Tempo Selects the modulation source for the
noise level
Amt –100…+100 Sets the modulation amount of the noise
level
e Click Level 0…100 Sets the click noise level
Src Off…Tempo Selects the modulation source for the
click noise level
Amt –100…+100 Sets the modulation amount of the click
noise level
f EQ Trim 0…100 Sets the EQ input level
g Pre EQ Cutoff [Hz] 300…10.00k Sets the EQ center frequency
Q 0.5…10.0 Sets the EQ band width
Gain [dB] –18.0…+18.0 Sets the EQ gain
h Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source