RIGOL DSG3000 Series - Manual (Page 80)

RIGOL Chapter 2 Command System
2-60 DSG3000 Programming Guide
[:SOURce]:PHASe:STEP[:INCRement]
Syntax [:SOURce]:PHASe:STEP[:INCRement]
[:SOURce]:PHASe:STEP[:INCRement]?
Description Set the phase offset step of RF output.
Query the phase offset step of RF output.
Parameter Name Type Range Default
Real 0.01deg to 180deg 1deg
Explanation  When is set in "Number" form, the default unit is deg. Besides,
can also be set in "Number + Unit" form, for example, 5deg.
 The default unit of the return value is deg.
 After setting the phase offset step, you can use the up/down direction keys or
knob to modify the phase offset at the current step. At this point, you can
query or set the phase offset using the [:SOURce]:PHASe command.
Return Format The query returns the phase offset step, for example, 5.000000.
Example :PHAS:STEP 5
:PHAS:STEP?
Related
Command
[:SOURce]:PHASe
[:SOURce]:PM Command Subsystem
Command List:
 [:SOURce]:PM:DEViation
 [:SOURce]:PM:DEViation:STEP[:INCRement]
 [:SOURce]:PM:FREQuency
 [:SOURce]:PM:FREQuency:STEP[:INCRement]
 [:SOURce]:PM:SOURce
 [:SOURce]:PM:STATe
 [:SOURce]:PM:WAVEform