RIGOL DSG3000 Series - Manual (Page 56)

RIGOL Chapter 2 Command System
2-36 DSG3000 Programming Guide
[:SOURce]:IQ:TRIGger:DURation
Syntax [:SOURce]:IQ:TRIGger:DURation
[:SOURce]:IQ:TRIGger:DURation?
Description Set the duration of the single trigger signal.
Query the duration of the single trigger signal.
Parameter Name Type Range Default
Integer 1 to 65535 1
Explanation  This command is valid only when selecting "Single" operation mode.
describes the number of points (
r
N
). The actual time (
r
T
) can be obtained
according to the current sample rate (
a
S ):
a r r
S N T
= .
 After the duration is set, you can use the up/down direction keys or knob to
modify the duration at the current step. You can query or set the current step
using the [:SOURce]:IQ:TRIGger:DURation:STEP command.
Return Format The query returns the duration of the single output signal, for example, 4000.
Example :IQ:TRIG:DUR 4000
:IQ:TRIG:DUR?
Related
Commands
[:SOURce]:IQ:TRIGger:DURation:STEP
[:SOURce]:IQ:TRIGger:OPTMode
[:SOURce]:IQ:TRIGger:DURation:STEP
Syntax [:SOURce]:IQ:TRIGger:DURation:STEP
[:SOURce]:IQ:TRIGger:DURation:STEP?
Description Set the duration step.
Query the duration step.
Parameter Name Type Range Default
Integer 1 to 10000 1
Explanation After setting the duration step, you can use the up/down direction keys or knob to
modify the duration at the current step. At this point, you can query or reset the
duration using the [:SOURce]:IQ:TRIGger:DURation command.
Return Format The query returns the duration step, for example, 500.
Example :IQ:TRIG:DUR:STEP 500
:IQ:TRIG:DUR:STEP?
Related
Command
[:SOURce]:IQ:TRIGger:DURation