RIGOL DSG3000 Series - Manual (Page 74)

RIGOL Chapter 2 Command System
2-54 DSG3000 Programming Guide
[:SOURce]:LFOutput:SWEPtsine:FREQuency:STOP:STEP
Syntax [:SOURce]:LFOutput:SWEPtsine:FREQuency:STOP:STEP
[:SOURce]:LFOutput:SWEPtsine:FREQuency:STOP:STEP?
Description Set the stop frequency step of sweep-sine.
Query the stop frequency step of sweep-sine.
Parameter Name Type Range Default
Real 100mHz to 500kHz 10kHz
Explanation  When is set in "Number" form, the default unit is Hz, for example,
3000. Besides, can also be set in "Number + Unit" form, for example,
3kHz.
 The default unit of the return value is Hz.
 After setting the stop frequency step, you can use the up/down direction keys
or knob to modify the stop frequency at the current step. At this point, you can
query or set the stop frequency using the
[:SOURce]:LFOutput:SWEPtsine:FREQuency:STOP command.
Return Format The query returns the stop frequency step of sweep-sine, for example, 3000.
Example :LFO:SWEP:FREQ:STOP:STEP 3kHz
:LFO:SWEP:FREQ:STOP:STEP?
Related
Command
[:SOURce]:LFOutput:SWEPtsine:FREQuency:STOP
[:SOURce]:LFOutput:SWEPtsine:LEVel
Syntax [:SOURce]:LFOutput:SWEPtsine:LEVel
[:SOURce]:LFOutput:SWEPtsine:LEVel?
Description Set the amplitude of sweep-sine.
Query the amplitude of sweep-sine.
Parameter Name Type Range Default
Real 1mV to 3V 1V
Explanation  When is set in "Number" form, the default unit is V. Besides,
can also be set in "Number + Unit" form, for example, 2V.
 The default unit of the return value is V.
 After setting the amplitude of sweep-sine, you can use the up/down direction
keys or knob to modify the amplitude at the current step. At this point, you
can query or set the current step using the
[:SOURce]:LFOutput:SWEPtsine:LEVel:STEP command.
Return Format The query returns the amplitude of sweep-sine, for example, 2.00.
Example :LFO:SWEP:LEV 2
:LFO:SWEP:LEV?
Related
Command
[:SOURce]:LFOutput:SWEPtsine:LEVel:STEP