RIGOL DSG3000 Series - Manual (Page 57)

Chapter 2 Command System RIGOL
DSG3000 Programming Guide 2-37
[:SOURce]:IQ:TRIGger:INHibit
Syntax [:SOURce]:IQ:TRIGger:INHibit
[:SOURce]:IQ:TRIGger:INHibit?
Description Set the external inhibit of IQ wave table.
Query the external inhibit of IQ wave table.
Parameter Name Type Range Default
Integer 0 to 65535 0
Explanation  After a trigger event occurs, the trigger signal is no longer received during the
external inhibit time.
 This command is valid only when selecting "Ext" trigger mode.
describes the number of points (
i
N
). The actual time (
i
T
) can be obtained
according to the current sample rate (
a
S ):
a i i
S N T
= .
 After the external inhibit is set, you can use the up/down direction keys or knob
to modify the inhibit at the current step. You can query or set the current step
using the [:SOURce]:IQ:TRIGger:INHibit:STEP command.
Return Format The query returns the external inhibit, for example, 5000.
Example :IQ:TRIG:INH 5000
:IQ:TRIG:INH?
Related
Commands
[:SOURce]:IQ:TRIGger:INHibit:STEP
[:SOURce]:IQ:TRIGger:MODe
[:SOURce]:IQ:TRIGger:INHibit:STEP
Syntax [:SOURce]:IQ:TRIGger:INHibit:STEP
[:SOURce]:IQ:TRIGger:INHibit:STEP?
Description Set the external inhibit step.
Query the external inhibit step.
Parameter Name Type Range Default
Integer 1 to 10000 1
Explanation After setting the external inhibit step, you can use the up/down direction keys or
knob to modify the external inhibit at the current step. At this point, you can query or
reset the external inhibit using the [:SOURce]:IQ:TRIGger:INHibit command.
Return Format The query returns the external inhibit step, for example, 555.
Example :IQ:TRIG:INH:STEP 555
:IQ:TRIG:INH:STEP?
Related
Command
[:SOURce]:IQ:TRIGger:INHibit