RIGOL DSG3000 Series - Manual (Page 24)

RIGOL Chapter 2 Command System
2-4 DSG3000 Programming Guide
*RST
Syntax *RST
Description Restore the RF signal generator to the preset state (factory or user).
Related
Command
:SYSTem:PRESet
*SRE
Syntax *SRE
*SRE?
Description Set the enable register for the status byte register.
Query the enable register for the status byte register.
Parameter Name Type Range Default
Integer 0 to 255 0
Explanation The bit 0 and bit 1 of the status byte register are not used and are always treated as
0, therefore, the range of are the decimal numbers corresponding to the
binary numbers ranging from 00000000 (0 in decimal) to 11111111 (255 in decimal)
and of which the bit 0 and bit 1 are 0.
Return Format The query returns an integer which equals the sum of the weights of all the bits that
have already been set in the register.
Example *SRE 16 /*Enable the bit 4 (16 in decimal) of the status byte register */
*SRE? /*The query returns 16*/
*STB?
Syntax *STB?
Description Query the event register for the status byte register. The value of the status byte
register is set to 0 after this command is executed.
Explanation The bit 0 and bit 1 of the status byte register are not used and are always treated as
0. The query returns the decimal numbers corresponding to the binary numbers
ranging from 00000000 (0 in decimal) to 11111111 (255 in decimal) and of which the
bit 0 and bit 1 are 0.
Return Format The query returns an integer which equals the sum of the weights of all the bits that
have already been set in the register.
*TRG
Syntax *TRG
Description Trigger a pulse modulation, RF sweep or LF sweep-sine immediately.
Related
Commands
:TRIGger:LFOutput[:IMMediate]
:TRIGger:PULSe[:IMMediate]
:TRIGger[:SWEep][:IMMediate]