RIGOL DSG3000 Series - Manual (Page 58)

RIGOL Chapter 2 Command System
2-38 DSG3000 Programming Guide
[:SOURce]:IQ:TRIGger:MODe
Syntax [:SOURce]:IQ:TRIGger:MODe AUTO|KEY|BUS|EXT
[:SOURce]:IQ:TRIGger:MODe?
Description Set the trigger mode of IQ wave table.
Query the trigger mode of IQ wave table.
Parameter Name Type Range Default
AUTO|KEY|BUS|EXT Discrete AUTO|KEY|BUS|EXT AUTO
Explanation  AUTO: select "Auto" trigger mode. The RF signal generator fulfills the trigger
condition at any time and it will output continuously the IQ baseband signal.
 KEY: select "Key" trigger mode. The instrument will output the baseband signal
each time Trigger at the front panel is pressed.
 BUS: select "Bus" trigger mode. The instrument will output the baseband signal
each time the *TRG or :TRIGger:IQ[:IMMediate] command is sent.
 EXT: select "Ext" trigger mode. The RF signal generator accepts the trigger
signal input from the [TRIGGER IN] connector at the rear panel. The
instrument will output the baseband signal each time a TTL pulse signal with the
specified polarity is received.
 When selecting "Ext" trigger, you can also set the "Ext Delay" and "Ext Inhibit".
Return Format The query returns the trigger mode of IQ wave table, for example, KEY.
Example :IQ:TRIG:MOD KEY
:IQ:TRIG:MOD?
Related
Commands
[:SOURce]:IQ:TRIGger:DELay
[:SOURce]:IQ:TRIGger:INHibit
*TRG
:TRIGger:IQ[:IMMediate]