Monitor list – Yaskawa iQpump Controller Programming Manual User Manual
Page 291

YASKAWA TM.iQp.07 iQpump Controller Programming Manual
291
Monitor List
Table 124 Monitor List
Parameter No.
Addr.
Hex
Parameter Name Digital
Operator Display
Description
Monitor
U1-01
0040
Auto Set-point Reference
Auto: Set-point
Auto Set-point Reference (speed command) monitor when in auto mode, frequency reference
(speed command) setting location when in hand mode. Units changeable via P1-02.
U1-02
0041
Output Frequency
Output Freq
Output frequency monitor in Hz.
U1-03
0042
Output Current
Output Current
Output current monitor.
U1-06
0045
Output Voltage
Output Voltage
Displays drive output voltage.
U1-07
0046
DC Bus Voltage
DC Bus Voltage
Displays DC bus voltage.
U1-08
0047
Output Power
Output kWatts
Displays drive output power.
U1-10
0049
Input Terminal Status
Input Term Sts
Displays drive input terminal status.
U1-11
004A
Output Terminal Status
Output Term Sts
Output terminal ON / OFF check.
U1-12
004B
Drive Operation Status
Int Ctl Sts 1
U1-13
004C
Cumulative Operation Time
Elapsed Time
Displays total operating or power-on time of the drive.
U1-14
004D
Software Number
FLASH ID
Displays drive's software number.
U1-15
004E
Terminal A1 Input Voltage
Term A1 Leve
l
Displays the input voltage on Terminal A1, as a percentage of 10 Vdc.
0
1: FWD. run
(Terminal S1) is ON.
1: REV. run
(Terminal S2) is ON.
1: Multi-function input 1
(Terminal S3) is ON.
1: Multi-function input 2
(Terminal S4) is ON.
1: Multi-function input 3
(Terminal S5) is ON.
1: Multi-function input 4
(Terminal S6) is ON.
1: Multi-function input 5
(Terminal S7) is ON.
0 0 0 0 0 0 0
1: Multi-function Contact 1
output 1 (Terminal M1-M2) is
ON.
1:Multi-function Contact 2
output 1 (Terminal M3-M4) is
ON.
Not used
Not used
1:Fault output
(Terminal MA/MB-MC) is
ON.
0 0 0 0 0 0 0 0
1: During running
1: During zero speed
1: During reverse
1: During reset signal input
1: During speed agree
1: Drive operation ready
1: During fault detection
(Minor fault)
1: During fault detection
(Major fault)
0 0 0 0 0 0 0 0