Yaskawa iQpump Controller Programming Manual - Manual (Page 134)

134 YASKAWA TM.iQp.07 iQpump Controller Programming Manual
For example, if the iQpump drive needs to display the Elapsed Timer as the Power-On monitor, then o1-01 must be set to “13” and o1-02
must be set to “4”. The next time iQpump drive power is cycled, the digital operator displays U1-13 (Elapsed Time), U1-14 (Flash ID),
and U1-15 (Term AI Level).
◆ o1-05 LCD Contrast Adjustment
Setting Range: 1, 3 or 5
Factory Default: 3
The contrast setting of the LCD display of the digital operator can be adjusted by the setting of parameter o1-05. The higher the number
programmed into o1-05, the darker the background will become. Set o1-05 to the value that makes the LCD the easiest to view at the
normal viewing distance and angle.
◆ o1-06 User Monitor Selection Mode
◆ o1-07 Second Line User Monitor
Setting Range: 1 ~ 94
Factory Default: 2
◆ o1-08 Third Line User Monitor
Setting Range: 1 ~ 94
Factory Default: 91
Normally the monitors shown directly below the active monitor are the next two sequential monitors. If o1-06 (User Monitor Selection
Mode) is set to “1: 3 Mon Selectable,” those two monitors are locked as specified by parameters o1-07 and o1-08 and will not change as
the top parameter is scrolled with the INCREASE and DECREASE keys.
Setting Description
0 3 Mon Sequential
1 3 Mon Selectable ( factory default )
Output Frequency
Output Current
-DRIVE- Rdy
Frequency Ref
U1- 01 = 60.00Hz
- - - - - - - - - - - - - - - - - - - - - - - - - - - - -
U1-02= 60.00Hz
U1-03= 10.05A
Active Monitor Next two
sequential
monitors
Active Monitor Title
-DRIVE- Rdy
Elapsed Time
U1-13= 2 H
- - - - - - - - - - - - - - - - - - - - - - - - - - - - -
U1-14= 03010
U1-16= 51.2%
Active Monitor
Active Monitor Title
Next two
sequential
monitors Flash ID
Term AI Level
15
-DRIVE- Rdy
PI Feedback
U1-24= 64.55%
- - - - - - - - - - - - - - - - - - - - - - - - - - - - -
U1-37= 0.00%
U1-38= 2.50%
Active Monitor
o1-07
o1-08
Active Monitor Title
PI Output
PI Setpoint
o1-07=37
o1-08=38