AMETEK BPS Series Programming Manual - Manual (Page 95)

BPS / MX / RS Series SCPI Programming Manual AMETEK Programmable Power
Manual P/N 7003-961 Rev. AA 95
4.17.7 List:TTL Trigger Out
LIST:TTLTrg
This command sets the sequence of Trigger Out list points. Each point which is set ON will
cause a pulse to be output at Trigger Out (Function strobe signal on the system interface)
when that list step is reached. Those entries which are set OFF will not generate Trigger Out
pulses. The order in which the list points are given determines the sequence in which
Trigger Out pulses will be output when a list transient is triggered.
Command Syntax [SOURce:]LIST:TTLTrg ,
Parameters 0|1|OFF|ON
Examples
LIST:TTLT 1,0,1 LIST:TTLT ON,OFF,ON
Query Syntax LIST:TTLT?
Returned Parameters 0 | 1
Related Commands LIST:TTLT:POIN? LIST:COUN LIST:DWEL
LIST:STEP OUTP:TTLT:STAT OUTP:TTLT:SOUR
LIST:TTLTrg:POINts?
This query returns the number of points specified in LIST:TTLT. Note that it returns only the
total number of points, not the point values.
Query Syntax [SOURce:]LIST:TTLTrg:POINts?
Returned Parameters
Example LIST:TTLT:POIN?
Related Commands
LIST:TTLT