AMETEK BPS Series Programming Manual - Manual (Page 92)

AMETEK Programmable Power BPS / MX / RS Series SCPI Programming Manual
92 Manual P/N 7003-961 Rev AA
4.17.3 List - Frequency
LIST:FREQuency
This command sets the sequence of frequency list points. The frequency points are given in
the command parameters, which are separated by commas. The order in which the points
are entered determines the sequence in which they are output when a list is triggered.
Command Syntax [SOURce:]LIST:FREQuency[:LEVel],
Parameters Values limited to the frequency range
Unit HZ (Hertz)
Examples LIST:FREQ 60,65,70
Query Syntax [SOURce:]LIST:FREQ?
Returned Parameters
Related Commands LIST:FREQ:POIN? LIST:COUN LIST:DWEL
LIST:STEP LIST:FREQ:SLEW
LIST:FREQuency:POINts?
This query returns the number of points specified in LIST:FREQuency. Note that it returns
only the total number of points, not the point values.
Query Syntax [SOURce:]LIST:FREQ[:LEVel]:POINts?
Returned Parameters
Example LIST:FREQ:POIN?
Related Commands
LIST:FREQ
LIST:FREQuency:SLEW
This command sets the sequence of frequency slew list points. The frequency points are
given in the command parameters, which are separated by commas.The order in which the
points are entered determines the sequence in which they are output when a list is triggered.
Command Syntax [SOURce:]LIST:FREQuency:SLEW,
Parameters 0.01 to 1E9
⏐MAXimum
Unit HZ (Hertz) per second
Examples LIST:FREQ:SLEW 10, 1E2, MAX
Query Syntax [SOURce:]LIST:FREQ:SLEW?
Returned Parameters
Related Commands LIST:FREQ:SLEW:POIN? LIST:COUN
LIST:DWEL LIST:STEP LIST:FREQ
LIST:FREQuency:SLEW:POINts?
This query returns the number of points specified in LIST:FREQuency:SLEW. Note that it
returns only the total number of points, not the point values.
Query Syntax [SOURce:]LIST:FREQ:SLEW:POINts?
Returned Parameters
Example LIST:FREQ:SLEW:POIN?
Related Commands
LIST:FREQ:SLEW