AMETEK BPS Series Programming Manual User Manual
Page 120
AMETEK Programmable Power
BPS / MX / RS Series SCPI Programming Manual
120
Manual P/N 7003-961 Rev AA
SYSTem:CONFigure:NOUTput
Sets the mode configuration of the power source to single-phase or a three-phase mode.
The MODE option must be enabled for this command to work. If MODE option is not
available, the query response will be FIX.
Command Syntax
SYSTem:CONFigure:NOUTput
Parameters
ONEPhase | THReephase
Example
SYST:CONF:NOUT ONE
Query Syntax
SYSTem:CONF?
Query response
ONE, THREE or FIX
Note: Query response CRD differs
from parameter format on this command.
Returned Paramters
SYSTem:ETIMe?
This command will return the total number of accumulated hours, minutes and seconds.
Command Syntax
SYSTem:ETIMe?
Parameters none
Example SYST:ETIM?
Returned Parameters
SYSTem:TEMPerature?
This command will return the internal ambient temperature of the AC/DC power source in
degrees Celsius.
Command Syntax
SYSTem:TEMPerature?
Parameters none
Example SYST:TEMP?
Returned Parameters
SYSTem:COMMunicate:GPIB:ADDRess
This command will set the GPIB address.
Command Syntax
SYSTem:COMMunicate:GPIB:ADDRess
Parameters
0 to 31
Example
SYST:COMM:GPIB:ADDR 2
Returned Parameters
SYSTem:COMMunicate:LAN:ADDRess
This command will set the LAN IP address. The query format returns the IP address set. To
query the actual IP address used by the LAN interface (in case the IP address is not static
but assigned by a DHCP server), the NCON parameter (Network Connection Setting) must
be added to the query. The default value is 0.0.0.0.