AMETEK BPS Series Programming Manual - Manual (Page 182)

AMETEK Programmable Power BPS / MX / RS Series SCPI Programming Manual
182 Manual P/N 7003-961 Rev AA
Command Syntax IEC413:FCURve:PAUSe
Parameters
Examples IEC413:FCURve:PAUS
2
Query Syntax IEC413:FCURve:PAUS?
Returned Parameters
IEC413:OSWing:LEVel
This command will set the level for the ‘over swing’ harmonics combination test. The
command has two parameters, one for the third and one for the fifth order harmonic. The
IEC413:STATe must be in the off position and the user class must be selected to accept the
command.
Command Syntax IEC413:OSWing:LEVel ,
Parameters 0 to 20%
Examples IEC413:OSWing:LEVel 10
Query Syntax IEC413:OSWing:LEVel?
Returned Parameters
IEC413:OSWing:DWELl
This command will set the dwell time in seconds for the over swing harmonics combination
test. The class must be selected prior to this command. Query with min and max to find the
range of the dwell time.
Command Syntax IEC413OSWing:DWELl
Parameters
Examples IEC413:OSWing:DWEL
10
Query Syntax IEC413:OSWing:DWEL?
Returned Parameters
IEC413:OSWing:PAUSe
This command will set the pause time in seconds. This is the time between tests when
RUN:ALL is selected. The class must be selected prior to this command. Query with min
and max to find the range of the pause time.
Command Syntax IEC413:OSWing:PAUSe
Parameters
Examples IEC413:OSWing:PAUS
2
Query Syntax IEC413:OSWing:PAUS?
Returned Parameters