AMETEK BPS Series Programming Manual - Manual (Page 38)

AMETEK Programmable Power BPS / MX / RS Series SCPI Programming Manual
38 Manual P/N 7003-961 Rev AA
4. SCPI Command Reference
4.1 Introduction
Related Commands
Where appropriate, related commands or queries are included. These are listed because
they are either directly related by function, or because reading about them will clarify or
enhance your understanding of the original command or query.
Subsystem commands
Subsystem commands are specific to AC/DC source functions. They can be a single
command or a group of commands. The groups are comprised of commands that extend
one or more levels below the root. The description of common commands follows the
description of the subsystem commands.
The subsystem command groups are listed in alphabetical order and the commands within
each subsystem are grouped alphabetically under the subsystem. Commands followed by a
question mark (?) take only the query form. When commands take both the command and
query form, this is noted in the syntax descriptions.
IEEE 488.2 common commands
Common commands are defined by the IEEE-488.2 standard and are described in chapter 0
of this manual.