AMETEK BPS Series Programming Manual - Manual (Page 50)

AMETEK Programmable Power BPS / MX / RS Series SCPI Programming Manual
50 Manual P/N 7003-961 Rev AA
4.2.9 Output - Impedance [MX15-1Pi/MX30-3Pi/MX45-3Pi/RS only]
CALibrate[:SOURce]:REAL[:FSCale]
This command will set the calibration coefficent for the real part of the output impedance.
Command Syntax CALibrate[:SOURce]:REAL[:FSCale]
Parameters (a value between 0 and +100)
Examples CAL:REAL +10
Query Syntax CALibrate[:SOURce]:REAL[:FSCale]?
Returned Parameters (value range 0 to +100)
Related Commands CALibrate[:SOURce]:REACtive[:FSCale]
CALibrate[:SOURce]:REAL:ZERO
This command will set the lowest real part of the output impedance that could be
programmed.
Command Syntax CALibrate[:SOURce]:REAL:ZERO
Parameters (a value between 0 and +100)
Examples CAL:REAL:ZERO 100
Query Syntax CALibrate[:SOURce]:REAL:ZERO?
Returned Parameters (value range 0 to +100)
Related Commands CALibrate[:SOURce]:REACtive:ZERO
CALibrate[:SOURce]:REACtive[:FSCale]
This command will set the calibration coefficent for the reactive part of the output
impedance.
Command Syntax CALibrate[:SOURce]:REACtive[:FSCale]
Parameters (a value between 0 and +300)
Examples CAL:REAL +10
Query Syntax CALibrate[:SOURce]:REACtive[:FSCale]?
Returned Parameters (value range 0 to +300)
Related Commands CALibrate[:SOURce]:REAL[:FSCale]
CALibrate[:SOURce]:REACtive:ZERO
This command will set the lowest reactive part of the output impedance that could be
programmed.
Command Syntax CALibrate[:SOURce]:REACtive:ZERO
Parameters (a value between 0 and +300)
Examples CAL:REACtive:ZERO 100
Query Syntax CALibrate[:SOURce]:REACtive:ZERO?
Returned Parameters (value range 0 to +300)
Related Commands CALibrate[:SOURce]:REAL:ZERO