AMETEK BPS Series Programming Manual - Manual (Page 195)

BPS / MX / RS Series SCPI Programming Manual AMETEK Programmable Power
Manual P/N 7003-961 Rev. AA 195
DO160:ABNormal:VOLTage:OVER
This command will set the voltage to the surge level for the abnormal operation.
Command Syntax DO160:ABNormal:VOLTage:OVER
Parameters none
Examples DO160:ABN:VOLT:OVER
Query Syntax
none
DO160:ABNormal:VOLTage:DC:LOW
This command will set the voltage to low voltage test for the abnormal operation. Refer to
Section 9.1 of the User Manual.
Command Syntax DO160:ABNormal:VOLTage:DC:LOW
Parameters none
Examples DO160:ABN:VOLT:DC:LOW
Query Syntax
none
DO160:ABNormal:FREQuency:TRANsient
This command applies to Group 1 only for the Eurocae standard. Refer to Table 12 in the
User Manual.
Command Syntax DO160:ABNormal:FREQuency:TRANsient
Parameters none
Examples DO160:ABN:FREQ:TRAN
Query Syntax
none
Returned Parameters none
DO160:CATegory
This command will select the proper equipment category in DC mode only. It has no effect
in AC mode.
Command Syntax DO160:CATegory
Parameters
Examples DO160:CAT
B
Query Syntax DO160:CAT?