AMETEK BPS Series Programming Manual - Manual (Page 43)

BPS / MX / RS Series SCPI Programming Manual AMETEK Programmable Power
Manual P/N 7003-961 Rev. AA 43
CALibrate:MEASure:CURRent:TEMPerature:DC[:FSCale]
This command initiates the calibration of the DC current measurement at elevated
temperature.
Command Syntax CALibrate:MEASure:CURRent:TEMPerature:DC[:FSCale]
Parameters (0 or desired offset value)
Examples CAL:MEAS:CURR:TEMP:DC
Query Syntax
CALibrate:MEASure:CURRent:TEMPerature:DC?
Returned Parameters (value range -1000 to + 1000
Related Commands CALibrate:MEASure:CURRent[:AMB]:DC[:FSCale]
CALibrate:MEASure:CURRent:TEMPerature:DC:ZERO
This command initiates the offset adjustment of the DC current measurement at elevated
temperature.
Command Syntax CALibrate:MEASure:CURRent:TEMPerature:DC:ZERO
Parameters (0 or desired offset value)
Examples CAL:MEAS:CURR:TEMP:DC:ZERO
Query Syntax
CALibrate:MEASure:CURRent:TEMPerature:DC:ZERO?
Returned Parameters (value range 0 to +5)
Related Commands CALibrate:MEASure:CURRent[:AMB]:DC:ZERO