AMETEK BPS Series Programming Manual - Manual (Page 39)

BPS / MX / RS Series SCPI Programming Manual AMETEK Programmable Power
Manual P/N 7003-961 Rev. AA 39
4.2 Calibration Subsystem
The commands in this subsystem allow you to do the following:
• Enable and disable the calibration mode
• Calibrate the measured current and measured voltage and store new calibration in
nonvolatile memory.
• Calibrate the current and voltage output levels, and store new calibration constants in
nonvolatile memory.
• Calibrate the output impedance of the AC source, and store new calibration constants in
nonvolatile memory.
Note: MX Series II models have fewer calibration points than series I models. The
Series II will accept all Series I calibration commands but some will have no
effect on Series II models. See the MX user manual 7003-960 or MX15 user
manual 7005-960 or RS user manual M440036 for specific calibration settings.
Also, the elevated temperature calibration setpoints are not required on Series
II MX/RS/BPS systems.
The commands in this subsystem allow you to do the following:
Subsystem Syntax
CALibrate
:PASSword Allows entry of calibration password required to
change calibration coefficients
:SAVE Saves new or modified calibration coefficients
:MEASure
:CURRent
[:AMBient]
Ambient temperature calibrations
[:AC]
[:FSCale] Calibrate full-scale AC current measurements
:DC
[:FSCale] Calibrate full-scale DC current measurements
:ZERO Cancel DC current measurements offset
:TEMPerature Elevated temperature calibrations
[:AC]
[:FSCale] Calibrate full-scale AC current measurements at
higher temperature
:DC
[:FSCale] Calibrate full-scale AC current measurements at
higher temperature
:ZERO Cancel AC current measurements offset at a higher
temperature
:VOLTage
[:AMBient]
Ambient temperature calibrations
[:AC]
[:FSCale] Calibrate full-scale AC voltage measurements
:DC
[:FSCale] Calibrate full-scale AC voltage measurements
:ZERO Cancel AC voltage measurements offset
:TEMPerature Elevated temperature calibrations
[:AC]