AMETEK BPS Series Programming Manual - Manual (Page 29)

BPS / MX / RS Series SCPI Programming Manual AMETEK Programmable Power
Manual P/N 7003-961 Rev. AA 29
Once completed, the dialog box shown above will appear signaling the device drivers have
been installed. The USB interface is now available to the PC’s operating system. To
complete the install process, click on the “Finish” button.
To verify the USB port is available, you can access the Windows System Properties screen,
select the Hardware tab and open the Windows Device Manager screen. The MX Source
should be listed under “Multi-port serial adapters” as shown in the image below.
Figure 3-3: Windows XP Device Manager - USB Port