Labconco PURICARE Procedure Station Models 34812xx - Manual (Page 101)

Page 101 of 197
Section Seven –
Purifier Type A2 Logic Service Operations
This section will review the tools needed, and common service operations for the Logic.
Recommended Tools for Service
The tools needed for most common service operations are:
9 Logic Certifier Kit, Labconco Part # 3858400
9 #2 Phillips Screwdriver or long bit for cordless drill
9 ½-inch Socket with extension and ratchet
9 ½-inch nut driver
9 7/16-inch socket or nut driver
9 5/16-inch socket or nut driver
Optional tools that may be needed include:
9 Cordless screwdriver/drill
9 Cordless ratchet
9 3/8-inch nut driver or socket and ratchet
9 Pliers
9 10-24 Tap
9 5/16 x 18 Tap
Note: If you use a cordless drill with an adjustable torque setting, set the
torque as low as possible to properly drive the screw or bolt.
External Dress Components
Front Dress Panel Removal and Installation
Figure 7-1
1. Locate and remove the two Phillips screws that
secure the front panel as shown in Figure 7-1.
They are located on the bottom corners of the
front
dress panel
2. Swing the bottom of the dress panel out to
clear the fluorescent light and then lift the
front dress panel straight up and away from
the
cabinet.