EXFO FTB-8100 Series Transport Blazer for FTB-200 - Manual (Page 92)

Creating and Starting a Test Case
80 FTB-8100 Series Transport Blazer
Typical Test Cases
2b. Under OTU tab, select the Enable FEC and Enable Scrambler
check boxes if needed. Refer to FEC TX on page 130 and OTU TX
on page 133 for more information.
2c. Under ODU tab, select 10G Ethernet as the mapping.
Link, located on the 10G Ethernet node, indicates the link status
of the 10G Ethernet RX signal. A green LED indicates a link up
while a red LED indicates a link down.
2d. Press the TCM button and select ODU TCM (TCM1 to TCM6) layers
as required.
3. Press the 10G Ethernet node.
3a. For OTU1e/OTU2e, if
required, select
the 10G Ethernet
Ethernet parameters.
Refer to Configuration
TX on page 325 for more
information.
4. Press the Pattern node.
4a. Set the pattern parameters. Refer to Pattern TX
on page 335 and Pattern RX on page 338 for
more information.