EXFO FTB-8100 Series Transport Blazer for FTB-200 - Manual (Page 394)

System Tab
382 FTB-8100 Series Transport Blazer
Default Test Preferences
Default Test Preferences
Press Main, System, Preferences, and Default Test Preferences.
Allows setting the default test parameters that will be applied every time a
test is created manually using Test Setup or when using SmartMode.
Changes to the default test preferences will only apply when a new test
case is created.
Note: The default test preferences are saved per slot on the FTB-200 meaning that
the configuration will not follow the module when changing the module
from one slot to another. However, a configuration on a specific slot will
remain when replacing a module by another module of the same model.
Configuration
³
Laser On: Selects Laser On every time a test is created manually using
the wizard or when using SmartMode. The Laser On check box is
selected by default.
³
STS-1 Fixed Stuff Columns
Enable Bulk Filled Override fills up the bytes of the STS-1 SPE’s
columns 30 and 59 with the selected pattern from the tab Pattern TX on
page 335 when the Enable Bulk Filled Override check box is
selected. The Enable Bulk Filled Override check box is selected by
default.