EXFO FTB-8100 Series Transport Blazer for FTB-200 - Manual (Page 70)

Creating and Starting a Test Case
58 FTB-8100 Series Transport Blazer
Typical Test Cases
3e. For DS1, select the Enable FDL check box to allow facility data
link testing. For Dual RX test, FDL is only available for the primary
DS1 TX/RX port.
3f. For DS1/E1, select the Enable DS0/E0 check box to allow DS0 or
E0 testing and select the Paylaod Content. Refer to Payload
Content on page 216 for DSn and page 304 for PDH.
4. Press the Pattern node.
4a. Set the pattern parameters. Refer to Pattern TX
on page 335 and Pattern RX on page 338 for
more information.
5. The test setup has been successfully created.
6. For additional configuration parameters and results, refer to Summary
Tabs on page 97, Port Tabs on page 113, DSn Tabs on page 213, PDH
Tabs on page 301, BERT Tabs on page 335, Advanced Tabs on
page 341, and Common Tabs on page 349.
7. Press the Start button to start the test. Pressing the start button while in
test setup window, will automatically switch to the Alarm summary
tab. Refer to Global Test Status and Controls on page 31 for more
information on test management.