EVCO EPU2LXP1CH Installer manual User Manual
Page 55
EVCO S.p.A.
c-pro 3 micro CHIL | Application manual ver. 1.0 | Codice 144CP3CHE104
page 55 of 120
8.5
Setting the RTC
When the power supply is disconnected from the controller for a few days, the RTC (Real Time Clock) system clock loses its time. When
the controller power is up again, it requires to reset the RTC alarm (enabled by PA30=1) and setting the correct date and time. In this
case, upon machine startupthe “Setting RTC” page will appear to set the time.
Once the clock has been configured, press OK to update the RTC time. The main application page will be shown. Pressing OK to
confirm the reset of the clock alarm (ERTC) at which point the conditions of the alarm has been restored.
If use the LED display type, set the date-time and then press right button to show the page for apply the modification. Press enter on
the “Set rtc” text to confirm the date-time.
In case the alarm doesn’t disappear: remove and reconnect the power of the controller and then manually reset the alarm.
Note. This function is enabled only if the parameter PG04=1, that is, if the system clock is enabled.