KEYENCE BL-600 Series - Manual (Page 153)

143
Chapter 8 PLC Link
8
8.5 Communication Time
This section describes the communication time required for data transmission
between the BL-600 Series and the PLC.
■ Time required data transmission
The time required for data transmission from the BL-600 to the PLC is as follows:
This communication time may change depending on the PLC’s scan time and the
model of the PLC.
* When the RS-232C communication baud rate is 9600 bps:
■ Communication time to start reading using reading trigger area
To control the BL-600 Series’ reading operation using the reading trigger area,
enter the trigger ON command on the PLC, and obtain the time duration until the
command is received by the BL-600.
* When the RS-232C communication baud rate is 9600 bps:
s t i g i d a t a d f o r e b m u N A - C E S L E M C - C A M S Y S ) e d o m V K ( V K
0 1 s m 0 2 2 . x o r p p A s m 0 3 3 . x o r p p A s m 0 4 4 . x o r p p A
0 2 s m 0 7 2 . x o r p p A s m 0 8 3 . x o r p p A s m 0 8 6 . x o r p p A
2 3 s m 0 2 3 . x o r p p A s m 0 6 4 . x o r p p A s m 0 2 9 . x o r p p A
A - C E S L E M C - C A M S Y S ) e d o m V K ( V K
s m 0 6 . x o r p p A s m 0 8 . x o r p p A s m 0 3 . x o r p p A