Aviom Pro64 Network Manager - Manual (Page 89)

80 P
ro
64 N
etwork
M
aNager
U
ser
g
Uide
Hardware and Software Standby Together
Both types of Standby can be used simultaneously if the AllFrame enters the software version of Standby
first. If while the AllFrame is in software Standby, a hardware contact closure is triggered on the same
AllFrame device, both types of Standby will be in force. On screen in the Device Window, the Standby
Mode o
N
radio button with be lit and the red h
ArDwAre
s
tANDBY
A
ctIve
will also be on.
An AllFrame in hardware standby
To exit this state, the hardware contact closure needs to be opened manually (the software Standby will
still be in force). Then, the software Standby can be disabled by either clicking the on‑screen o
FF
button in
the Device Window or pushing the gray s
tANDBY
momentary switch on the AllFrame hardware.
Standby and External Clocks
When an AllFrame device is the network’s Control Master and is set to use external AES or Word Clock,
entering standby will force the clock source to be set to Network (internal) clock while the AllFrame is in
standby. When the AllFrame comes out of standby the external clock will again be the network’s clock
source, as long as the C4dio card containing the clock connection is in the same physical location (slot A‑F)
in the AllFrame hardware and the external clock source is still connected.