5 storm-control multicast, 6 storm-control multicast level, 7 storm-control multicast all – Kontron AT8902 Full Size CLI User Manual
Page 82

AT8901/2/3
AT8901/2/3 CLI Reference Manual
Page 2 - 48
Format
no storm-control broadcast all level
Mode
Global Config
2.11.5
storm-control multicast
This command enables multicast storm recovery mode for an interface. If the mode is
enabled, multicast storm recovery is active, and if the rate of L2 multicast traffic
ingressing on an interface increases beyond the configured threshold, the traffic will be
dropped. Therefore, the rate of multicast traffic will be limited to the configured
threshold.
Default
disabled
Format
storm-control multicast
Mode
Interface Config
2.11.5.1
no storm-control multicast
This command disables multicast storm recovery mode for an interface.
Format
no storm-control multicast
Mode
Interface Config
2.11.6
storm-control multicast level
This command configures the multicast storm recovery threshold for an interface and
enables multicast storm recovery mode. If the mode is enabled, multicast storm
recovery is active, and if the rate of L2 multicast traffic ingressing on an interface
increases beyond the configured threshold, the traffic will be dropped. Therefore, the
rate of multicast traffic will be limited to the configured threshold.
Default
5
Format
storm-control multicast level
<0-100>
Mode
Interface Config
2.11.6.1
no storm-control multicast level
This command sets the multicast storm recovery threshold to the default value for an
interface and disables multicast storm recovery.
Format
no storm-control multicast level
Mode
Interface Config
2.11.7
storm-control multicast all
This command enables multicast storm recovery mode for all interfaces. If the mode is
enabled, multicast storm recovery is active, and if the rate of L2 multicast traffic
ingressing on an interface increases beyond the configured threshold, the traffic will be
dropped. Therefore, the rate of multicast traffic will be limited to the configured
threshold.
Default
disabled