2 ip access-group, 3 acl-trapflags, Ip access-group - 29 – Kontron AT8902 Full Size CLI User Manual
Page 193: Acl-trapflags - 29

AT8901/2/3
Page 4 - 29
AT8901/2/3 CLI Reference Manual
4.8.1.1
no access-list
This command deletes an IP ACL that is identified by the parameter
<
accesslistnumber>
from the system. The range for <
accesslistnumber>
1-99 for
standard access lists and 100-199 for extended access lists.
Format
no access-list
Mode
Global Config
4.8.2
ip access-group
This command attaches a specified IP ACL to one interface or to all interfaces.
An optional sequence number may be specified to indicate the order of this IP access
list relative to other IP access lists already assigned to this interface and direction. A
lower number indicates higher precedence order. If a sequence number is already in
use for this interface and direction, the specified access list replaces the currently
attached IP access list using that sequence number. If the sequence number is not
specified for this command, a sequence number that is one greater than the highest
sequence number currently in use for this interface and direction is used.
Default
none
Format
ip access-group
4294967295>]
Modes
Interface Config
Global Config
4.8.2.1
no ip access-group
This command removes a specified IP ACL from an interface.
Default
none
Format
no ip access-group
Mode
Interface Config
4.8.3
acl-trapflags
This command enables the ACL trap mode.
Default
disabled
Format
acl-trapflags
Mode
Global Config
4.8.3.1
no acl-trapflags
This command disables the ACL trap mode.
Format
no acl-trapflags
Mode
Global Config