7 host, 8 lease, 9 network (dhcp pool config) – Kontron AT8902 Full Size CLI User Manual
Page 231: Host - 35, Lease - 35, Network (dhcp pool config) - 35
AT8901/2/3
Page 5 - 35
AT8901/2/3 CLI Reference Manual
Default
ethernet
Format
hardware-address
Mode
DHCP Pool Config
5.9.6.1
no hardware-address
This command removes the hardware address of the DHCP client.
Format
no hardware-address
Mode
DHCP Pool Config
5.9.7
host
This command specifies the IP address and network mask for a manual binding to a
DHCP client. Address and Mask are valid IP addresses; each made up of four decimal
bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid. The prefix-length is an
integer from 0 to 32
Default
none
Format
host
[{Mode
DHCP Pool Config
5.9.7.1
no host
This command removes the IP address of the DHCP client.
Format
no host
Mode
DHCP Pool Config
5.9.8
lease
This command configures the duration of the lease for an IP address that is assigned
from a DHCP server to a DHCP client. The overall lease time should be between 1-
86400 minutes. If you specify
infinite
, the lease is set for 60 days. You can also
specify a lease duration.
Days
is an integer from 0 to 59.
Hours
is an integer from 0 to
1439.
Minutes
is an integer from 0 to 86399.
Default
1 (day)
Format
lease [{
Mode
DHCP Pool Config
5.9.8.1
no lease
This command restores the default value of the lease time for DHCP Server.
Format
no lease
Mode
DHCP Pool Config
5.9.9
network (DHCP Pool Config)
Use this command to configure the subnet number and mask for a DHCP address pool
on the server. Network-number is a valid IP address, made up of four decimal bytes