Kontron AT8902 Full Size CLI - Manual (Page 244)

Management Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 6 - 4
Default burnedin
Format
network mac-type {local | burnedin}
Mode Privileged EXEC
6.1.7.1 no network mac-type
This command resets the value of MAC address to its default.
Format
no network mac-type
Mode Privileged EXE
6.1.8 show network
This command displays configuration settings associated with the switch's network
interface. The network interface is the logical interface used for in-band connectivity
with the switch via any of the switch's front panel ports. The configuration parameters
associated with the switch's network interface do not affect the configuration of the
front panel ports through which traffic is switched or routed.
Format show network
Modes Privileged EXEC
User EXEC
IP Address The IP address of the interface. The factory default value is 0.0.0.0
Subnet Mask The IP subnet mask for this interface. The factory default value is
0.0.0.0
Default Gateway The default gateway for this IP interface. The factory default
value is 0.0.0.0
Burned In MAC Address The burned in MAC address used for in-band connectiv-
ity.
Locally Administered MAC Address If desired, a locally administered MAC
address can be configured for in-band connectivity. To take effect,
'MAC Address Type' must be set to 'Locally Administered'. Enter the
address as twelve hexadecimal digits (6 bytes) with a colon between
each byte. Bit 1 of byte 0 must be set to a 1 and bit 0 to a 0, i.e. byte 0
should have the following mask 'xxxx xx10'. The MAC address used
by this bridge when it must be referred to in a unique fashion. It is rec-
ommended that this be the numerically smallest MAC address of all
ports that belong to this bridge. However it is only required to be
unique. When concatenated with dot1dStpPriority a unique
BridgeIdentifier is formed which is used in the Spanning Tree Proto-
col.
MAC Address Type Specifies which MAC address should be used for in-band con-
nectivity. The choices are the burned in or the Locally Administered
address. The factory default is to use the burned in MAC address.
Network Configuration Protocol Current Indicates which network protocol is
being used. The options are bootp | dhcp | none.