Kontron AT8902 Full Size CLI - Manual (Page 225)

AT8901/2/3
Page 5 - 29 AT8901/2/3 CLI Reference Manual
5.7.2 show key-features
This command displays the enabled or disabled status for all keyable features.
Format
show key-features
Modes Privileged EXEC
User EXEC
Function This is the name of the keyable component or feature.
Status Enabled or disabled.
5.8 Simple Network Time Protocol (SNTP) Commands
This section describes the commands you use to automatically configure the system
time and date by using SNTP.
5.8.1 sntp broadcast client poll-interval
This command sets the poll interval for SNTP broadcast clients in seconds as a power
of two where can be a value from 6 to 16.
Default 6
Format
sntp broadcast client poll-interval
Mode Global Config
5.8.1.1 no sntp broadcast client poll-interval
This command resets the poll interval for SNTP broadcast client back to the default
value.
Format
no sntp broadcast client poll-interval
Mode Global Config
5.8.2 sntp client mode
This command enables Simple Network Time Protocol (SNTP) client mode and may
set the mode to either broadcast or unicast.
Default disabled
Format
sntp client mode [broadcast | unicast]
Mode Global Config
5.8.2.1 no sntp client mode
This command disables Simple Network Time Protocol (SNTP) client mode.
Format.
no sntp client mode
Mode Global Config
5.8.3 sntp client port
This command sets the SNTP client port id to a value from 1-65535.