Kontron AT8902 Full Size CLI - Manual (Page 175)

AT8901/2/3
Page 4 - 11 AT8901/2/3 CLI Reference Manual
4.3.8 match destination-address mac
This command adds to the specified class definition a match condition based on the
destination MAC address of a packet. The parameter is any layer 2 MAC
address formatted as six, two-digit hexadecimal numbers separated by colons (e.g.,
00:11:22:dd:ee:ff). The < macmask> parameter is a layer 2 MAC address bit mask, which
need not be contiguous, and is formatted as six, two-digit hexadecimal numbers
separated by colons (e.g., ff:07:23:ff:fe:dc).
NOTE: This command is not available on the Broadcom 5630x platform.
Default none
Format
match destination-address mac
Mode Class-Map Config
4.3.9 match dstip
This command adds to the specified class definition a match condition based on the
destination IP address of a packet. The
parameter specifies an IP address.
The parameter specifies an IP address bit mask and must consist of a
contiguous set of leading 1 bits.
Default none
Format
match dstip
Mode Class-Map Config
4.3.10 match dstl4port
This command adds to the specified class definition a match condition based on the
destination layer 4 port of a packet using a single keyword or numeric notation. To
specify the match condition as a single keyword, the value for
>
is one of the
supported port name keywords. The currently supported > values are: domain,
echo, ftp, ftpdata, http, smtp, snmp, telnet, tftp, www . Each of these translates into its equivalent
port number. To specify the match condition using a numeric notation, one layer 4 port
number is required. The port number is an integer from 0 to 65535.
Default none
Format match dstl4port { | <0-65535>}
Mode Class-Map Config
4.3.11 match ip dscp
This command adds to the specified class definition a match condition based on the
value of the IP DiffServ Code Point (DSCP) field in a packet, which is defined as the
high-order six bits of the Service Type octet in the IP header (the low-order two bits are
not checked). The
value is specified as either an integer from 0 to 63, or
symbolically through one of the following keywords: af11, af12, af13, af21, af22, af23, af31,
af32, af33, af41, af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef .
NOTE: The ip dscp, ip precedence, and ip tos match conditions are alternative
ways to specify a match criterion for the same Service Type field in
the IP header, but with a slightly different user notation.