beautypg.com

12 set bootstopkey, 13 ping, 14 quit – Kontron AT8902 Full Size CLI User Manual

Page 222: 15 reload

background image

AT8901/2/3

AT8901/2/3 CLI Reference Manual

Page 5 - 26

5.6.12

set bootstopkey

This command sets the bootstop key. With this key the booting process can be stopped.

The key name is “stop”. This is the default setting.
Format

set bootstopkey

Mode

Privileged EXEC

5.6.12.1

no set bootstopkey

This command resets the bootstop key. The boot process can not be interrupted.
Format

no set bootstopkey

Mode

Privileged EXEC

5.6.13

ping

This command checks if another computer is on the network and listens for
connections. To use this command, configure the switch for network (in-band)
connection. The source and target devices must have the ping utility enabled and
running on top of TCP/IP. You can ping the switch from any IP workstation the switch
is connected to through the default VLAN (VLAN 1), as long as there is a physical
path between the switch and the workstation. The terminal interface sends three pings
to the target station.

Format

ping

Modes

Privileged EXEC
User EXEC

5.6.14

quit

This command closes the current telnet connection or resets the current serial
connection. The system asks you whether to save configuration changes before
quitting.

Format

quit

Modes

Privileged EXEC
User EXEC

5.6.15

reload

This command resets the switch without powering it off. Reset means that all network
connections are terminated and the boot code executes. The switch uses the stored
configuration to initialize the switch. You are prompted to confirm that the reset should
proceed. The LEDs on the switch indicate a successful reset.

Format

reload

Mode

Privileged EXEC