6 radius server retransmit, 7 radius server timeout, 8 show radius – Kontron AT8902 Full Size CLI User Manual
Page 267: Radius server retransmit - 27, Radius server timeout - 27, Show radius - 27

AT8901/2/3
Management Commands
Page 6 - 27
AT8901/2/3 CLI Reference Manual
command will become the new primary server. The IP address must match that of a
previously configured RADIUS authentication server.
Format
radius server primary
Mode
Global Config
6.8.6
radius server retransmit
This command sets the maximum number of times a request packet is re-transmitted
when no response is received from the RADIUS server. The retries value is an integer
in the range of 1 to 15.
Default
4
Format
radius server retransmit
Mode
Global Config
6.8.6.1
no radius server retransmit
This command sets the maximum number of times a request packet is re-transmitted, to
the default value.
Format
no radius server retransmit
Mode
Global Config
6.8.7
radius server timeout
This command sets the timeout value (in seconds) after which a request must be
retransmitted to the RADIUS server if no response is received. The timeout value is an
integer in the range of 1 to 30.
Default
5
Format
radius server timeout
Mode
Global Config
6.8.7.1
no radius server timeout
This command sets the timeout value to the default value.
Format
no radius server timeout
Mode
Global Config
6.8.8
show radius
This command is used to display the various RADIUS configuration items for the
switch as well as the configured RADIUS servers. If the optional token 'servers' is not
included, the following RADIUS configuration items are displayed.
Format
show radius [servers]
Mode
Privileged EXEC
Primary Server IP Address Shows the configured server currently in use for
authentication.