1 users name, 2 users passwd, Users name - 13 – Kontron AT8902 Full Size CLI User Manual
Page 253: Users passwd - 13

AT8901/2/3
Management Commands
Page 6 - 13
AT8901/2/3 CLI Reference Manual
NOTE: You cannot delete the admin user, and there is only one user allowed
with read/write privileges. You can configure up to five read-only
users on the system.
6.5.1
users name
This command adds a new user account, if space permits. The account
can
be up to eight characters in length. You can use alphanumeric characters as well as the
dash (‘-’) and underscore (‘_’). You can define up to six user names.
NOTE: The
is not case sensitive when you add and delete users,
and when the user logs in. However, when you use the
to
set the user password, authentication, or encryption, you must enter
the
in the same case you used when you added the user.
To see the case of the
, enter the
show users
command.
Format
users name
Mode
Global Config
6.5.1.1
no users name
This command removes a user account.
Format
no users name
Mode
Global Config
NOTE: You cannot delete the “admin” user account.
6.5.2
users passwd
Use this command to change a password. Passwords are a maximum of eight
alphanumeric characters. If a user is authorized for authentication or encryption is
enabled, the password length must be at least eight alphanumeric characters. The
password is case sensitive. When you change a password, a prompt asks for the old
password. If there is no password, press enter. You must enter the
in the
same case you used when you added the user. To see the case of the
, enter
the
show users
command.
Default
no password
Format
users passwd
Mode
Global Config
6.5.2.1
no users passwd
This command sets the password of an existing user to blank. When you change a
password, a prompt asks for the old password. If there is no password, press enter.
Format
no users passwd
Mode
Global Config