Kontron AT8902 Full Size CLI - Manual (Page 145)

AT8901/2/3
Page 3 - 33 AT8901/2/3 CLI Reference Manual
the type is encrypt, the key may be up to 256 bytes. If the type is encrypt a <
keyid
> in
the range of 0 and 255 must be specified. Unauthenticated interfaces do not need an
authentication key or authentication key ID.
Default none
Format
ip ospf authentication {none | {simple } | {encrypt
}}
Mode Interface Config
3.7.28.1 no ip ospf authentication
This command sets the default OSPF Authentication Type for the specified interface.
Format
no ip ospf authentication
Mode Interface Config
3.7.29 ip ospf cost
This command configures the cost on an OSPF interface. The <
cost
> parameter has a
range of 1 to 65535.
Default 10
Format ip ospf cost <1-65535>
Mode Interface Config
3.7.29.1 no ip ospf cost
This command configures the default cost on an OSPF interface.
Format
no ip ospf cost
Mode Interface Config
3.7.30 ip ospf dead-interval
This command sets the OSPF dead interval for the specified interface. The value for
<
seconds
> is a valid positive integer, which represents the length of time in seconds
that a router's Hello packets have not been seen before its neighbor routers declare that
the router is down. The value for the length of time must be the same for all routers
attached to a common network. This value should be some multiple of the Hello
Interval (i.e. 4). Valid values range for seconds is from 1 to 2147483647.
Default 40
Format
ip ospf dead-interval
Mode Interface Config
3.7.30.1 no ip ospf dead-interval
This command sets the default OSPF dead interval for the specified interface.
Format no ip ospf dead-interval
Mode Interface Config