Kontron AT8902 Full Size CLI - Manual (Page 36)

AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 2 - 2
2. Switching Commands
This chapter describes the switching commands available in the CLI.
The Switching Commands chapter includes the following sections:
• 2.1 “Port Configuration Commands” on page 2 - 2
• 2.2 “Spanning Tree Protocol (STP) Commands” on page 2 - 6
• 2.3 “VLAN Commands” on page 2 - 17
• 2.4 “Double VLAN Commands” on page 2 - 27
• 2.5 “Provisioning (IEEE 802.1p) Commands” on page 2 - 29
• 2.6 “Protected Ports Commands” on page 2 - 30
• 2.7 “GARP Commands” on page 2 - 32
• 2.8 “GVRP Commands” on page 2 - 33
• 2.9 “GMRP Commands” on page 2 - 35
• 2.10 “Port-Based Network Access Control Commands” on page 2 - 37
• 2.11 “Storm-Control Commands” on page 2 - 46
• 2.12 “Port-Channel/LAG (802.3ad) Commands” on page 2 - 52
• 2.13 “Port Mirroring” on page 2 - 56
• 2.15 “IGMP Snooping Configuration Commands” on page 2 - 59
• 2.16 “Port Security Commands” on page 2 - 65
• 2.17 “LLDP (802.1AB) Commands” on page 2 - 67
• 2.18 “Denial of Service Commands” on page 2 - 73
• 2.19 “MAC Database Commands” on page 2 - 76
CAUTION: The commands in this chapter are in one of three functional
groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration
setting.
• Clear commands clear some or all of the settings to factory defaults.
2.1 Port Configuration Commands
This section describes the commands you use to view and configure port settings.
2.1.1 interface
This command gives you access to the Interface Config mode, which allows you to
enable or modify the operation of an interface (port).
Format
interface <slot/port>
Mode Global Config
2.1.2 auto-negotiate
This command enables automatic negotiation on a port.
Default enabled
Format auto-negotiate