Kontron AT8902 Full Size CLI - Manual (Page 103)

AT8901/2/3
Page 2 - 69 AT8901/2/3 CLI Reference Manual
Format
lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-
desc]
Mode Interface Config
2.17.4.1 no lldp transmit-tlv
Use this command to remove an optional TLV from the LLDPDUs. Use the command
without parameters to remove all optional TLVs from the LLDPDU.
Format.
no lldp transmit-tlv [sys-desc] [sys-name] [sys-cap]
[port-desc]
Mode Interface Config
2.17.5 lldp transmit-mgmt
Use this command to include transmission of the local system management address
information in the LLDPDUs.
Format
lldp transmit-mgmt
Mode Interface Config
2.17.5.1 no lldp transmit-mgmt
Use this command to include transmission of the local system management address
information in the LLDPDUs. Use this command to cancel inclusion of the
management information in LLDPDUs.
Format no lldp transmit-mgmt
Mode Interface Config
2.17.6 lldp notification
Use this command to enable remote data change notifications.
Default disabled
Format
lldp notification
Mode Interface Config
2.17.6.1 no lldp notification
Use this command to disable notifications.
Default disabled
Format no lldp notification
Mode Interface Config
2.17.7 lldp notification-interval
Use this command to configure how frequently the system sends remote data change
notifications. The
parameter is the number of seconds to wait between
sending notifications. The valid interval range is 5-3600 seconds.
Default 5