Kontron AT8902 Full Size CLI - Manual (Page 260)

Management Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 6 - 20
6.6.12 snmp-server enable traps linkmode
This command enables Link Up/Down traps for the entire switch. When enabled, link
traps are sent only if the Link Trap flag setting associated with the port is enabled.
“snmp trap link-status” on page 6 - 22.
Default enabled
Format
snmp-server enable traps linkmode
Mode Global Config
6.6.12.1 no snmp-server enable traps linkmode
This command disables Link Up/Down traps for the entire switch.
Format
no snmp-server enable traps linkmode
Mode Global Config
6.6.13 snmp-server enable traps multiusers
This command enables Multiple User traps. When the traps are enabled, a Multiple
User Trap is sent when a user logs in to the terminal interface (EIA 232 or Telnet) and
there is an existing terminal interface session.
Default enabled
Format
snmp-server enable traps multiusers
Mode Global Config
6.6.13.1 no snmp-server enable traps multiusers
This command disables Multiple User traps.
Format
no snmp-server enable traps multiusers
Mode Global Config
6.6.14 snmp-server enable traps stpmode
This command enables the sending of new root traps and topology change notification
traps.
Default enabled
Format
snmp-server enable traps stpmode
Mode Global Config
6.6.14.1 no snmp-server enable traps stpmode
This command disables the sending of new root traps and topology change notification
traps.
Format
no snmp-server enable traps stpmode
Mode Global Config