Kontron AT8902 Full Size CLI - Manual (Page 62)

AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 2 - 28
Default vman
Format
dvlan-tunnel ethertype {802.1Q | vman | custom} [0-65535]
Mode Global Config
2.4.1.1 no dvlan-tunnel etherType
This command configures the ether-type for all interfaces to the default value.
Format no dvlan-tunnel ethertype
Mode Global Config
2.4.2 mode dot1q-tunnel
This command is used to enable Double VLAN Tunneling on the specified interface.
Default disabled
Format
mode dot1q-tunnel
Mode Interface Config
2.4.2.1 no mode dot1q-tunnel
This command is used to disable Double VLAN Tunneling on the specified interface.
By default, Double VLAN Tunneling is disabled.
Format no mode dot1q-tunnel
Mode Interface Config
2.4.3 mode dvlan-tunnel
Use this command to enable Double VLAN Tunneling on the specified interface.
NOTE: When you use the
mode dvlan-tunnel
command on an interface, it
becomes a service provider port. Ports that do not have double VLAN
tunneling enabled are customer ports.
Default disabled
Format
mode dvlan-tunnel
Mode Interface Config
2.4.3.1 no mode dvlan-tunnel
This command is used to disable Double VLAN Tunneling on the specified interface.
By default, Double VLAN Tunneling is disabled.
Format
no mode dvlan-tunnel
Mode Interface Config
2.4.4 show dot1q-tunnel
Use this command without the optional parameters to display all interfaces enabled for
Double VLAN Tunneling. Use the optional parameters to display detailed information
about Double VLAN Tunneling for the specified interface or all interfaces.