Kontron AT8902 Full Size CLI - Manual (Page 71)

AT8901/2/3
Page 2 - 37 AT8901/2/3 CLI Reference Manual
600 centiseconds (0.2 to 6.0 seconds). The factory default is 60 centi-
seconds (0.6 seconds).
LeaveAll Timer This Leave All Time controls how frequently LeaveAll PDUs are
generated. A LeaveAll PDU indicates that all registrations will shortly
be deregistered. Participants will need to rejoin in order to maintain
registration. There is an instance of this timer on a per-Port, per-GARP
participant basis. The Leave All Period Timer is set to a random value
in the range of LeaveAllTime to 1.5*LeaveAllTime. Permissible val-
ues are 200 to 6000 centiseconds (2 to 60 seconds). The factory default
is 1000 centiseconds (10 seconds).
Port GMRP Mode Indicates the GMRP administrative mode for the port. It may be
enabled or disabled. If this parameter is disabled, Join Time, Leave
Time and Leave All Time have no effect.
2.9.4 show mac-address-table gmrp
This command displays the GMRP entries in the Multicast Forwarding Database
(MFDB) table.
Format
show mac-address-table gmrp
Mode Privileged EXEC
Mac Address A unicast MAC address for which the switch has forwarding and or
filtering information. The format is 6 or 8 two-digit hexadecimal num-
bers that are separated by colons, for example 01:23:45:67:89:AB. In
an IVL system the MAC address is displayed as 8 bytes.
Type Displays the type of the entry. Static entries are those that are config-
ured by the end user. Dynamic entries are added to the table as a result
of a learning process or protocol.
Description The text description of this multicast table entry.
Interfaces
The list of interfaces that are designated for forwarding (Fwd:) and fil-
tering (Flt:).
2.10 Port-Based Network Access Control Commands
This section describes the commands you use to configure port-based network access
control (802.1x). Port-based network access control allows you to permit access to
network services only to and devices that are authorized and authenticated.
2.10.1 authentication login
This command creates an authentication login list. The is any character
string and is not case sensitive. Up to 10 authentication login lists can be configured on
the switch. When a list is created, the authentication method “local” is set as the first
method.
When the optional parameters “Option1”, “Option2” and/or “Option3” are used, an
ordered list of methods are set in the authentication login list. If the authentication
login list does not exist, a new authentication login list is first created and then the
authentication methods are set in the authentication login list. The maximum number